Paradigm Soundtrack System Manuel d'utilisateur télécharger pdf (Page 10)

IR Learning Codes

Your Soundtrack System is capable of learning certain codes from remote

controls you already own, such as the volume code from your TV’s remote.

Each code must be programmed in separately. To program, follow the

steps below.

Step 1

Press and hold for 3 seconds the button on the soundbar’s Onboard

Interface for the desired function to be programmed (eg. volume, source,

mute, on/off).

Step 2

The Soundtrack’s LED will start to ﬂash indicating that the system is now

in ‘IR learning’ mode.

Step 3

Aim the source’s remote control at the front of the soundbar and press

the corresponding function button on the source’s remote.

Step 4

Repeat from Step 1 to program each additional function.

NOTE: To learn a MUTE command from a remote control you already

own, press the Sync button on top of the soundbar for 3 seconds then

move to Step 2 above.

Your existing cable/satellite box remote control or TV remote control

may use a code that the Soundtrack System cannot learn. In these

instances you will have to use the remote control that came with your

system or use a universal or learning remote control.

CONNECTION

For quick setup of soundbar and subwoofer, refer to the instructions

in the Set-Up Guide.

SETTING UP THE SOUNDBAR

See Set-Up Guide.

SETTING UP THE SUBWOOFER

(Shown) Back panel of

Subwoofer. See pg. 8 for

description of numbered

functions.

FINAL_SoundtrackManual_ENG_FRE_SPA_READER_SPREADS.indd 7 12-10-12 12:01 PM

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 39 40

Pas de commentaire

Paradigm Soundtrack System Manuel d'utilisateur Page 10